7435A REV B Norge Dryer Parts List

Moisture sensor (sensor, electrode)

This is the moisture sensor for your dryer. It helps detect the amount of moisture in your clothes during the dryer cycle. If you notice your clothes are still wet after an automatic dryer cycle is done, you may need to replace the sensor. You will find the moisture sensor behind the lint screen. Be sure to disconnect the power source from the dryer before you begin this repair. Note: Some model's require two sensors, please order quantity needed. Sensor only, harness is not included. This part is sold individually.

Idler pulley wheel (idler pulley)

The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Bi-metal defrost thermostat (defrost, bimetal)

If ice is building up in your freezer or if your freezer is getting too warm on the defrost cycle you may need to replace the bi-metal thermostat.

Freezer door handle (sub 12610802w)

Screws NOT included.

Door handle (handle,door)

Handle ONLY.

Temperature sensor (oven probe)

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is 9 inches in length and is a genuine OEM part. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.

Heating element brass nut (nut)

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Dairy door - clear (door-dairy)

Drain pump - 60hz 120v (drain pump and motor assembly)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

Drip bowl - 6 inch (chrome drip bowl for 6" burner, electric range)

This is the drip bowl for your range or cooktop. The drip bowl sits beneath the burner of an electric range and collects any spills during cooking. The bowl is 6 inches in diameter and represents the smaller burner for your range. This product is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Water inlet valve (water valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. This valve has a 3/8" inlet and comes with the mounting bracket.

Retaining ring

The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.

Door handle end cap (oven door handle end cap, white)

This end cap can be used for either the left or right side.

Rotary start switch (switch rotary start)

This part is used to start the dryer once you have selected a setting on the timer.

Lint filter with frame (filter asm)

This part may differ in appearance, but functions same as original.